LEMON Manuals: Even more car manuals for everyone
Home >> Tesla >> 2024 >> Model 3 Long Range >> Repair and Diagnosis (Single Page) >> Accessories & Equipment >> Seats -- Model 3 >> 2nd Row Seat Assemblies and Hardware >> 2nd Row Seat Back Hardware - 2nd Row Seatback Hinge Bracket Assembly - LH - Remove And Replace >> Remove

2nd Row Seat Back Hardware - 2nd Row Seatback Hinge Bracket Assembly - LH - Remove And Replace: Remove

  1. Remove the LH 2nd row seat side bolster. See 2ND ROW SEAT ASSEMBLIES - 2ND ROW BOLSTER - LH - REMOVE AND REPLACE .
  2. Remove the 2nd row lower seat cushion. See 2ND ROW SEAT ASSEMBLIES - 2ND ROW SEAT CUSHION - REMOVE AND REPLACE .
  3. Remove the LH 2nd row seat back. See 2ND ROW SEAT ASSEMBLIES - 2ND ROW SEATBACK - LH - REMOVE AND REPLACE .
  4. Use a clip prytool, release the clip that secures the seat heater connector to the hinge bracket.
    G16589012Courtesy of TESLA, INC.
  5. Remove the bolt securing the seat back hinge bracket and then remove the seat back hinge bracket from the seat back.

    Tip: Use of the following tool(s) is recommended:

    • Cordless Ratchet/Impact Driver
    • 13 mm socket
    • 3 in extension
    • Flex head ratchet/flex head torque wrench (for installation only)
    G16589013Courtesy of TESLA, INC.
    G16589014Courtesy of TESLA, INC.
scientia non olet · About LEMON Manuals