Front Lights - Assembly, Side Repeater LH - Remove And Replace: Remove
- Open the LH front door and lower the LH front window.
- Press the brake pedal to turn on the drive rail and turn the steering wheel fully to the left.
- Apply protective tape to the LH front fender around the LH front side repeater assembly.WARNING: The video(s) included in this procedure are meant as an overview for supplemental purposes only. Follow all of the steps listed in the procedure to avoid damage to components and/or personal injury.multimedia:A supplement to the article is available.
- Release the clips (x4) to partially remove the LH front wheel arch liner to gain access to the working area, as illustrated.
- Release the tabs (x3) that attach the LH front side repeater assembly to the LH front fender, and then separate the light from the fender.NOTE: Release the rearmost tab first.CAUTION: If reinstalling the same side repeater, take care not to damage the mounting tabs.WARNING: The video(s) included in this procedure are meant as an overview for supplemental purposes only. Follow all of the steps listed in the procedure to avoid damage to components and/or personal injury.multimedia:A supplement to the article is available.
- Disconnect the LH front side repeater assembly connectors (x2), and then remove the assembly from the vehicle.CAUTION: Wrap the terminals of the camera and wiring harness to prevent them from coming into contact with water or other solutions that could cause damage.