Instrument Panel - Instrument Panel - Dash Panel - Glove Box USB Module - Remove And Replace: Install

Install the bolts (x2) that attach the glove box USB module to the glove box.
1.5 N.m (1.1 lbs-ft)

Tip: Use of the following tool(s) is recommended:
- Torx T25 socket
- Ratchet/torque wrench
- Torque Wrench 1/4 in Dr Hexagon - 1060071-00-A (for installation only)
Courtesy of TESLA, INC.
Connect the glove box USB cable to the car computer.
NOTE: Engage the locking tab after connecting the connector.

Courtesy of TESLA, INC.
Install the clips (x2) that attach the passenger footwell duct to the vehicle.

Courtesy of TESLA, INC.
For NA vehicles only: Install the RH knee airbag assembly. See FRONT AIR BAGS - KNEE AIR BAG, RH - REMOVE AND REPLACE .
Install the passenger footwell cover. See DASH PANEL - PASSENGER FOOTWELL COVER ASSEMBLY - REMOVE AND REPLACE .
Connect a laptop with Toolbox 3 to the vehicle. See TOOLBOX 3 - CONNECT AND DISCONNECT .
In Toolbox 3, select the Actions/Autodiag tab, and then search for "TEST-BASH_CID_X_USB3-GLOVEBOX".
Click TEST-BASH_CID_X_USB3-GLOVEBOX, and then click Run .
NOTE: After the routine ends, click the "X" at the upper right corner of the prompt.
Disconnect the laptop with Toolbox 3 from the vehicle. See TOOLBOX 3 - CONNECT AND DISCONNECT .
Close the LH front door.