Infotainment - Touchscreen - Touchscreen - Rear Display - Remove And Replace: Install

Install the bolts (x5) that attach the rear display to the rear end module.
1 N.m (.7 lbs-ft)

Tip: Use of the following tool(s) is recommended:
- Torx T20 socket
- Cordless Ratchet/Impact Driver
- 4 in extension
- Torque Wrench Hexagon - 1060071-00-A (for installation only)
Courtesy of TESLA, INC.
Install the rear end module assembly. See CENTER CONSOLE - REAR END MODULE, ASSEMBLY - REMOVE AND REPLACE
Connect LV battery power. See LV BATTERY - LI-LON - DISCONNECT AND CONNECT
Install the rear underhood apron. See UNDERHOOD TRIM - REAR APRON ASSEMBLY - REMOVE AND REPLACE .
Install LH center console decor trim. See CENTER CONSOLE - HOCKET STICK, LH, ASSEMBLY - REMOVE AND REPLACE .
Install LH center console front side panel. See CENTER CONSOLE - CONSOLE SIDE PANEL, CARPET, LH, LHD - REMOVE AND REPLACE .
Install LH center console rear side panel. See CENTER CONSOLE - REAR SIDE PANEL, LH, ASSEMBLY - REMOVE AND REPLACE .
Repeat step 5 through step 7 for the RH side of the vehicle.
Install the center console rear end panel. See CENTER CONSOLE - CONSOLE REAR END PANEL, ASSEMBLY - REMOVE AND REPLACE
Install the center console phone dock. See PHONE DOCK (CLIP) - INTERIOR TRIM - CENTER CONSOLE - REMOVE AND REPLACE .
Connect a laptop with Toolbox 3 to the vehicle. See TOOLBOX 3 - CONNECT AND DISCONNECT .
In Toolbox, click the Actions/Autodiag tab, and then type "PING-BASH_DISPLAY" into the search field.
Click PING-BASH_DISPLAY-REAR⁽ⁱ⁾ , click Run , and allow the routine to complete.
Disconnect the laptop with Toolbox 3 from the vehicle. See TOOLBOX 3 - CONNECT AND DISCONNECT .