LEMON Manuals: Even more car manuals for everyone
Home >> Tesla >> 2024 >> Model 3 Long Range >> Repair and Diagnosis (Single Page) >> Accessories & Equipment >> Communication Devices >> Electrical System (2 Of 2) -- Model 3 >> Wipers and Washers >> Electrical - Wipers and Washers - Windshield Washer Bottle and Pump - Washer Level Sensor - Remove And Replace >> Remove

Electrical - Wipers and Washers - Windshield Washer Bottle and Pump - Washer Level Sensor - Remove And Replace: Remove

  1. Remove the underhood storage unit. See EXTERIOR FITTINGS - LUGGAGE COMPARTMENT TRIM - FRONT LUGGAGE STORAGE COMPARTMENT - FRUNK ASSEMBLY - REMOVE AND REPLACE .
  2. Open the washer reservoir cap.
  3. Place a fluid evacuator near the front of the vehicle and connect it with a compressed air.
  4. Open the evacuator valve and position the evacuator hose into a corner of the washer reservoir, and then evacuate as much as washer as possible.
  5. Disconnect the compressed air and remove the fluid evacuator.
  6. Disconnect the windshield washer level sensor connector.
    G16596487Courtesy of TESLA, INC.
  7. Use a plastic trim tool to gently pry the washer level sensor from the washer reservoir.
    CAUTION: Be careful not to damage the sensor.
    G16596488Courtesy of TESLA, INC.
    G16596489Courtesy of TESLA, INC.
  8. Remove the grommet from the washer level sensor, inspect for damage and replace if necessary.
    G16596490Courtesy of TESLA, INC.
    G16596491Courtesy of TESLA, INC.
scientia non olet · About LEMON Manuals