Electrical - Wipers and Washers - Windshield Washer Bottle and Pump - Washer Level Sensor - Remove And Replace: Install
- Install the grommet into the windshield washer reservoir.
 Courtesy of TESLA, INC.
|
 Courtesy of TESLA, INC.
|
- Install the windshield washer level sensor so that the flat edge of the sensor housing is facing upwards and the sensor connector is facing directly to the rear.
 Courtesy of TESLA, INC.
|
- Connect the windshield washer level sensor connector.
 Courtesy of TESLA, INC.
|
- Install the underhood storage unit. See EXTERIOR FITTINGS - LUGGAGE COMPARTMENT TRIM - FRONT LUGGAGE STORAGE COMPARTMENT - FRUNK ASSEMBLY - REMOVE AND REPLACE
.
- Fill the windshield washer reservoir with fluid.
- Close the washer reservoir cap.
- Verify operation of the windshield wipers and washer.