Carrier - Rocker Panel - LH - Remove And Replace: Install

Position the LH rocker panel carrier onto the vehicle, and then install the push clip and new bolts (x10) that attach the carrier to the vehicle.
3 N.m (2.2 ft-lbs)

Tip: Use of the following tool(s) is recommended:
- 8 mm socket
Courtesy of TESLA, INC.

Courtesy of TESLA, INC.

Courtesy of TESLA, INC.
Position the LH rocker panel onto the body, and then secure the clips (x14) that attach the panel to the body.
NOTE: Verify the rocker is seated correctly around the lift pads.

Courtesy of TESLA, INC.

Courtesy of TESLA, INC.
Install the bolts (x4) that attach the LH rocker panel to the body.
3 N.m (2.2 ft-lbs)

Tip: Use of the following tool(s) is recommended:
- 10 mm socket
Courtesy of TESLA, INC.

Courtesy of TESLA, INC.
Secure the bolt covers (x4) on the LH rocker panel.

Courtesy of TESLA, INC.

Courtesy of TESLA, INC.
Install the LH rear rocker panel fairing. See FAIRING - ROCKER PANEL - REAR - LH (REMOVE AND REPLACE) .
Install the screw and push clip that attach the front of the LH rocker panel to the vehicle.
3 N.m (2.2 ft-lbs)

Tip: Use of the following tool(s) is recommended:
- T25 socket
Courtesy of TESLA, INC.

Courtesy of TESLA, INC.
Secure the clips (x3) and tabs (x2) that attach the rear portion of the LH front fender garnish to the vehicle.
NOTE: Fully engage clips.

Courtesy of TESLA, INC.

Courtesy of TESLA, INC.

Courtesy of TESLA, INC.
Close the LH falcon wing door.
Raise the LH front window and close the LH front door.