Camera - Triple - Forward Facing - Remove And Replace: Install

Clean the inner windshield camera viewing area with a clean microfiber cloth and glass cleaner. Let the windshield fully dry before continuing.
CAUTION: Verify that the windshield has no stains or leftover residue. Otherwise, Autopilot features may be hindered.

Courtesy of TESLA, INC.
Position the forward facing triple camera into the vehicle, connect the connectors (x2), and then secure the locking tabs.

Courtesy of TESLA, INC.
Position the triple camera to the camera mounting bracket, and then install the screws (x4) that attach the mounting plate to the winshield.
0.8 N.m (7 in-lbs)

NOTE: Allow the camera to hang by the harness.

Tip: Use of the following tool(s) is recommended:
- T10 socket
Courtesy of TESLA, INC.
Position the glare shield assembly to the windshield, and then install bolts (x2) that attach the assembly to the windshield.
1 N.m (.7 ft-lbs)

NOTE: Slide the tabs into the triple camera assembly and align the datums.

Tip: Use of the following tool(s) is recommended:
- Torx T10 bit
Courtesy of TESLA, INC.
Secure the heater grid electrical harness to the hooks (x2) and the connector retainer.

Courtesy of TESLA, INC.
Connect the GPS antenna connector.

Courtesy of TESLA, INC.
Connect the forward facing camera fan electrical connector.

Courtesy of TESLA, INC.
Perform pitch verification. See Camera - Forward Facing (Pitch Verification) .