Seal - Rear Door Cantrail - LH - Remove And Replace: Install

Position the LH rear door cantrail seal onto the door assembly, and then install the bolts (x4) that attach the sides of the seal to the door assembly.
3.5 N.m (2.6 ft-lbs)

Tip: Use of the following tool(s) is recommended:
- T25 socket
Courtesy of TESLA, INC.

Courtesy of TESLA, INC.

Courtesy of TESLA, INC.
Tighten the nuts (x7) that attach the underside of the LH rear door cantrail seal to the door assembly.
5 N.m (3.7 ft-lbs)

Tip: Use of the following tool(s) is recommended:
- 8 mm socket
Courtesy of TESLA, INC.
Remove the masking tape from the LH rear door rear pinch sensor, position the sensor onto the door assembly, and then install the push clips (x7) that attach the sensor to the door assembly.

Courtesy of TESLA, INC.
Remove the masking tape from the LH rear door front pinch sensor, position the sensor onto the door assembly, and then install the push clips (x7) that attach the sensor to the door assembly.

Courtesy of TESLA, INC.
Install the LH upper rear door glass assembly. See DOOR GLASS ASSEMBLY - REAR - UPPER - LH (REMOVE AND REPLACE) .