LEMON Manuals: Even more car manuals for everyone
Home >> Tesla >> 2023 >> Model 3 Performance >> Repair and Diagnosis (Single Page) >> Accessories & Equipment >> Seats -- Model 3 >> Front Seat Tracks and Motors >> Track - Inner - Front Passenger Seat - Remove and Replace >> Install

Track - Inner - Front Passenger Seat - Remove and Replace: Install

  1. Line up the seat track covers (x2) to the front edge of the seat rail, slide the covers onto the seat rail until they are secure.
    G00637894Courtesy of TESLA, INC.
  2. Install the front passenger seat inner track onto the track bridge assembly.
    G00637895Courtesy of TESLA, INC.
    NOTE: The track motor cable is keyed square and must be aligned with inner track. Turn cable by hand to align as needed. Slide the track motor bridge into the inner track until is fully seated.
    G00637896Courtesy of TESLA, INC.
    G00637897Courtesy of TESLA, INC.
  3. Install new bolts that attach the front passenger seat outer track to the seat assembly.
    G00637902Courtesy of TESLA, INC.
    G00637903Courtesy of TESLA, INC.

    23 Nm (17.0 lbs-ft 

    Tip: Use of the following tool(s) is recommended:

    • Torx T50 socket

  4. Position the seat track position sensor to the seat track assembly, and then install the screw that attaches the sensor to the assembly.
    G00637900Courtesy of TESLA, INC.

    Tip: Use of the following tool(s) is recommended:

  5. Connect the seat track position sensor electrical connector.
    G00637899Courtesy of TESLA, INC.
  6. Return the seat to the upright position.
  7. Install the front passenger seat buckle. See BUCKLE - 1ST ROW - LH (REMOVE AND REPLACE) .
  8. Install the front passenger seat inboard side shield from the seat assembly. See SIDE SHIELD - INBOARD - DRIVER SEAT (REMOVE AND REPLACE) .
  9. Install the front passenger seat into the vehicle. See SEAT ASSEMBLY - 1ST ROW (LH) - REMOVE AND REPLACE .
  10. If servicing the front passenger seat in a North American vehicle: 
    1. Remove all objects from the front passenger seat before beginning calibration.
    2. On the vehicle touchscreen, touch Controls (Vehicle Icon) > Software  and check the vehicle firmware version. If the vehicle firmware is 2023.2.11 or newer, perform a software reinstall. See SOFTWARE REINSTALL - TOUCHSCREEN . If the vehicle firmware is not 2023.2.11 or newer, update the vehicle firmware. See SOFTWARE UPDATE .
    3. Locally connect a laptop with Toolbox 3 to the vehicle. See TOOLBOX 3 - CONNECT AND DISCONNECT .
    4. Unlock the vehicle gateway. See GATEWAY (UNLOCK) .
    5. In Toolbox, click on the Actions  tab, and then search for "OCS".
    6. Run  the PROC_OCS1P_SELF-CALIBRATION routine.
    7. Click on the Actions  tab, and then search for "Seat calibration"
    8. Run  the PROC_VCRIGHT_SEAT-TEST-CALIBRATE routine.
    9. Disconnect Toolbox and remove the laptop from the vehicle.
scientia non olet · About LEMON Manuals