LEMON Manuals: Even more car manuals for everyone
Home >> Tesla >> 2023 >> Model 3 Performance >> Repair and Diagnosis (Single Page) >> Accessories & Equipment >> Interior/Exterior Trim >> Body -- Model 3 >> Body Panels >> Carrier - Front End - Remove and Replace >> Install

Carrier - Front End - Remove and Replace: Install

  1. Install the clips that attach the front end module electrical harness to the front end carrier.
    G14738918Courtesy of TESLA, INC.
  2. Install the hood latch. See LATCH - HOOD (REMOVE AND REPLACE) .
  3. Install the secondary hood latch actuator. See ACTUATOR - LATCH - HOOD - SECONDARY (REMOVE AND REPLACE) .
  4. With an assistant, position the front end carrier onto the vehicle for installation.
    NOTE: Hand-tighten the upper bolts of the front end carrier to avoid it from falling when installing the ankle catcher.
  5. Install the ankle catcher. See ANKLE CATCHER (REMOVE AND REPLACE) .
  6. Connect the AGS actuator electrical connector.
  7. Install the high tone horn. See HORN - HIGH TONE (REMOVE ND REPLACE) .
  8. Install the low tone horn. See HORN - LOW TONE (REMOVE AND REPLACE) .
  9. Install the bolts that attach the radar bracket to the front end carrier.

    8 N.m (5.9 ft-lbs) 

    G14738919Courtesy of TESLA, INC.
  10. Install the front Bluetooth passive entry antenna. See ANTENNA - BLUETOOTH PASSIVE ENTRY - FRONT (REMOVE AND REPLACE) .
  11. Install the HomeLink transmitter module. See MODULE - HOMELINK TRANSMITTER (REMOVE AND REPLACE) .
  12. Install the front radar sensor. See SENSOR - RADAR - FRONT (REMOVE AND REPLACE) .
  13. Connect the electrical harness onto the RH front end carrier electrical connector.
    G14738920Courtesy of TESLA, INC.
  14. Connect the electrical harness onto the LH front end carrier electrical connector.
    G14738921Courtesy of TESLA, INC.
  15. Install the front bumper. See BUMPER BEAM - FRONT (REMOVE AND REPLACE) .
  16. Install the front fascia assembly. See FASCIA - FRONT (REMOVE AND INSTALL) .
  17. Install the underhood storage unit. See UNDERHOOD STORAGE UNIT (REMOVE AND REPLACE) .
  18. Install the hood latch cover. See COVER - HOOD LATCH (REMOVE AND REPLACE) .
  19. Install the cabin intake duct. See DUCT - CABIN INTAKE (REMOVE AND REPLACE) .
  20. Install the rear underhood apron. See UNDERHOOD APRON - REAR (REMOVE AND REPLACE) .
  21. Remove the vehicle from the lift.
scientia non olet · About LEMON Manuals