Headlight - LH - Remove and Replace: Install

Position the LH headlight onto the body.
CAUTION: Do not damage the headlight during installation.
Install the fasteners that attach the LH headlight to the body.
5.9 N.m (4.4 ft-lbs)

NOTE: The headlight might not be equipped with a lower fastener.

Tip: Use of the following tool(s) is recommended:
- 10 mm socket
- 1/4 in std ratchet
- 1/4 in torque wrench (installation only)
- 2 in extension
Courtesy of TESLA, INC.

Courtesy of TESLA, INC.
Install the bolt that attaches the fender bracket to the body.
3 Nm (2.2 lbs-ft)
- Torx T20 socket
- in std ratchet
- in torque wrench (installation only)
- 4 in extension
Courtesy of TESLA, INC.
Connect the electrical connector for the LH headlight.

Courtesy of TESLA, INC.
Install the front fascia. See FASCIA - FRONT (REMOVE AND INSTALL) .
NOTE: After connecting the front fascia electrical connections, pause the procedure to initiate a software reinstall.
Perform a software reinstall concurrently with the rest of the steps in this procedure. See SOFTWARE REINSTALL - TOUCHSCREEN .
NOTE: After initiating the software reinstall, continue the front fascia installation.
Install the underhood storage unit. See UNDERHOOD STORAGE UNIT (REMOVE AND REPLACE) .
Install the hood latch cover. See COVER - HOOD LATCH (REMOVE AND REPLACE) .
Install the cabin intake duct. See DUCT - CABIN INTAKE (REMOVE AND REPLACE) .
Install the rear underhood apron. See UNDERHOOD APRON - REAR (REMOVE AND REPLACE) .
Adjust the headlights:
Fig 1: Headlight Fasteners With Torque Specifications
Courtesy of TESLA, INC.