Post Guide - Headrest - Front Passenger Seat - Remove and Replace: Remove
- Check that the firmware is version 2023.2.11 or above. If the firmware version is not 2023.2.11 or above, update the vehicle firmware.
- Remove the front passenger seat assembly from the vehicle. See Seat Assembly - 1st Row (LH) - Remove and Replace
- Remove the front passenger seat outboard side shield. See Side Shield - Outboard - Driver Seat - Remove and Replace
- Remove the front passenger seat inboard side shield. See Side Shield - Inboard - Driver Seat - Remove and Replace
- Lay the seat on its seat back to gain access to the underside of the seat cushion.CAUTION: Protect the seat cushion from damage as necessary.
- Release the clips that attach the shell apron to the underside of the seat.
- Disconnect the seat back heater connector.
- Slide the seat back harness connector straight down to release it from the seat assembly.
- Disconnect the seat cushion heat pad connector from the seat back head pad connector.
- Slide the seat cushion connector upward to release it from the seat assembly.
- Return the seat to the upright position.
- Remove the front passenger headrest trim. See Trim - Headrest - Driver - Remove and Replace
- Remove the front passenger back shell. See Shell - Seat Back - Driver - Remove and Replace
- Remove the front passenger seat back trim retainers (x7) from the seat back frame.
- Remove the lower flap that covers the outboard corner of the front passenger seat seat back frame.NOTE: Pull the trim straight up, off of the retaining tabs to release it.
- Remove the upper flap that covers the outboard corner of the front passenger seat seat back frame.NOTE: Pull the lower section of trim away from the retaining tab to release it, then pull the trim straight up off of the upper retaining tab.
- Remove the lower flap covering the inboard corner of the front passenger seat seat back frame.NOTE: Pull the trim straight up, off of the retaining tabs to release it.
- Remove the upper flap that covers the inboard corner of the front passenger seat seat back frame.NOTE: Pull the lower section of trim away from the retaining tab to release it, and then pull the trim straight up off of the upper retaining tab.
- Pull the front passenger seat seat back trim away from the front passenger seat side airbag to gain access to the air bag electrical connector.
Figure 1. LH shown: RH similar
- Disconnect the front passenger seat side airbag and pull the orange tabs (x2) down to release the connector.
Figure 2. LH shown: RH similar
- Remove the bolt that attaches the lumbar support assembly to the seat frame.
5 Nm (3.7 lbs-ft)
NOTE: The bolt is located below the lumbar ECU. Removing this bolt allows ease of access for the following step.Tip:
Use of the following tool(s) is recommended:
- Release the tabs (x2) that attach the bottom of the lumbar support to the seat back frame.
- Remove and discard the nuts (x2) that attach the front passenger seat side airbag to the seat back frame.
5.4 Nm (4.0 lbs-ft)
Tip:
Use of the following tool(s) is recommended:
- 10 mm socket
Figure 3. LH shown; RH similar
- Carefully pull the front passenger seat side airbag chute from the seat back frame.CAUTION: Do not remove the airbag from the airbag chute.
Figure 4. LH shown; RH similar
- Remove the seat upholstery by pulling the bottom of the seat back trim away from the seat back frame.NOTE: Make sure the heater harness and the seat back trim is clear of the seat back frame.
- Release the RH side headrest post guide from the seat back frame.NOTE: Press in the headrest guide post clips, and then gently tap the base of the guide post with the hammer to release it.