LEMON Manuals: Even more car manuals for everyone
Home >> Tesla >> 2023 >> Model 3 Long Range >> Repair and Diagnosis (Single Page) >> Accessories & Equipment >> Mirrors >> Exterior Fittings -- Model 3 >> Badges and Films >> Rear Lettering - Retrofit >> Procedure

Rear Lettering - Retrofit: Procedure

  1. Clean the trunk area where the "Dual Motor" badge is to be installed with an isopropyl alcohol (IPA) wipe.
  2. Put the badge fixture tool in position on the trunk and secure it with masking tape.
    NOTE: Make sure the badge and adhesion surface are between 60-120 degrees Fahrenheit (15.556-43.333 Celsius). Use a heat gun in cold weather conditions to bring installation surfaces to optimum temperature.
    G14739774Courtesy of TESLA, INC.
  3. Remove the badge liner on the adhesive side, and then set the badge in the badge fixture using the datum holes.
    G14739775Courtesy of TESLA, INC.
  4. Adhere the badge to the trunk by pressing through the badge fixture window.
  5. Remove the clear front liner from the badge. Do not discard the liner at this time.
  6. Remove the badge fixture and masking tape from the trunk.
  7. Reapply the clear front liner to the badge to protect the surface.
  8. Use the silicone seam roller to fully adhere the badge.
    G14739776Courtesy of TESLA, INC.
  9. Remove the clear front liner from the badge.
scientia non olet · About LEMON Manuals