Fascia - Front - Remove and Install: Install

Installation procedure is the reverse of removal, except for the following:

• Align the fascia to the fender before tightening the bolts that attach the fascia to the fender.
• Perform a radar sensor calibration only if the front radar sensor likely moved outside of its calibration tolerance (contact while removing the fascia, etc.). See SENSOR - RADAR - FRONT (CALIBRATION) .
  NOTE: If radar sensor calibration is required, add the correction code separately.
• Apply a thin bead of Loctite 222 to the threads of the bolts (x4) that attach the front aero shield panel to the vehicle.