Fender Support - Front - LH - Remove and Replace: Install
- Install the bolts (x3) that attach the LH front fender support to the vehicle.
- 10 mm socket
- Ratchet/torque wrench
Tip: Use of the following tool(s) is recommended:
35 N.m (25.8 lbs-ft)
- Install the bolt that attaches the LH front fender support to the front fender assembly.
- 10 mm socket
- Ratchet/torque wrench
Tip: Use of the following tool(s) is recommended:
9.8 N.m (7.2 lbs-ft)
- Install the bolt that attaches the LH front fender support to the front end carrier.
16 N.m (11.8 lbs-ft)
- 13 mm socket
- 3 in extension
- Ratchet/torque wrench
Tip: Use of the following tool(s) is recommended:
- Route the front harness through the LH fender support, and secure the harness to the fender support.
- Connect the LH front ride height sensor connector.
- Connect the LH front wheel speed sensor connector.
- Install the front harness clips (x3) around the LH front wheel liner area.NOTE:
American region vehicles have 2 clips.
- Install the clips (x3) that attach the front harness to the LH crush can.
- Connect the front harness from the LH acceleration sensor.
- Connect the connectors (x2) to the horn assembly.
- Connect the front harness connector for the LH front carrier harness.
- Connect the cooling fan module connector.
- Install the front harness clips (x2) around the LH headlamp area.
- Connect the LH headlamp connector.
- Install the front fascia. See Fascia - Front - Remove and Install
- Connect 12V power. See 12V/LV POWER - DISCONNECT AND CONNECT