Fascia Assembly - Rear - Upper - Remove And Replace: Remove
- Open the LH front door and lower the front windows.
- Remove the rear fascia assembly from the vehicle. See FASCIA ASSEMBLY - REAR (REMOVE AND INSTALL) .
- Remove the rear fascia harness. See Harness - Fascia - Rear (Remove and Replace) .
- Remove the screws (x2) and release tab that attach the RH rear BLE to the upper rear fascia assembly, and then remove the BLE from the fascia. Repeat this step for the LH rear BLE.
3 N.m (2.2 ft-lbs)
Tip: Use of the following tool(s) is recommended:
- Torx T25 socket
- Remove the park assist sensors (x6) from the upper rear fascia assembly.
- Remove the screws (x4) that attach the upper rear fascia assembly to the lower rear fascia assembly.
Tip: Use of the following tool(s) is recommended:
- 10 mm socket
- Release the tabs (x21) that attach the upper rear fascia assembly to the lower rear fascia assembly, and then remove the upper assembly from the lower assembly.