Glove Box - With Knee Airbags (Heat Pump) - Remove And Replace: Remove
- Open both front doors
- Lower both front windows.
- Move RH front seat backward
- Open hoodNOTE:
Press "Open" button on touchscreen to release latch, Lift lid manually
- Remove rear apronNOTE:
12x clips, Only store rear apron visible face upwards
- Power off vehicle from center displayNOTE:
Via Controls > Safety > Power Off, Select Power Off button at warning dialogue box
- Disconnect 12V negative terminalNOTE:
1x nut, 10mm, 6 Nm, Ensure vehicle is in park, climate control system is off, and vehicle is not charging before disconnecting 12V
- Disconnect first responder loopNOTE:
1x connector, Release locking tab
- Remove LH IP end capNOTE:
3x clips
- Remove LH air wave bezel cap from main decor assemblyNOTE:
2x clips, Newer vehicles are equipped with solid bezel.
- Remove RH IP end capNOTE:
3x clips
- Remove RH air wave bezel cap from main decor assemblyNOTE:
2x clips, Newer vehicles are equipped with solid bezel.
- Remove main decor assemblyNOTE:
15x clips, Entire decor does not need to come off for glove box removal, If you lift RH side of decor then you will have access to 3x torx screws securing top of glove box, Replace securing clips as needed
- Release RH footwell assembly from IPNOTE:
4x push clips
- Remove RH footwell assemblyNOTE:
Remove RH footwell assembly
- Remove bolts securing passenger knee air bag onto vehicleNOTE:
4x patch bolts, T30, 8 Nm, Discard after removal, 2x screws, T20, 2 Nm, 1x push clip, Newer vehicles have 4x E10 patch bolts
- Remove passenger knee air bag from vehicleNOTE:
1x connector, Release locking tab, Connector release may vary
- Disconnect glove box USB cable from car computerNOTE:
1x connector, Depress latch on top of USB cable to release internal latches, then release from car computer
- Remove screws securing glove box assembly to IP carrierNOTE:
6x screws, T20, 2.3 Nm
- Remove glove box from IP carrierNOTE:
3x clips
- Disconnect glove box assembly connectorsNOTE:
3x electrical connectors