Cover - Seat Back - 2nd Row - RH (7-Seat) - Remove and Replace: Install
- Position the RH 2nd row seat back cover onto the foam, and then install the hog rings (x3) and secure the hook and loop around the perimeter.NOTE: Small cable ties may be used as a substitute for the hog rings. If cable ties are used, trim the excess cable flush, and then rotate the head away from the visible areas.
- Position the seat back shell into the RH 2nd row seat back cover, and then secure the tabs (x16) that attach the cover to the seat back shell.NOTE: Make sure the cover is evenly distributed on the front of the back rest.
- Connect the seat heating connector.
- Position the RH 2nd row seat back cover into the vehicle, and then install the seat back assembly into the seat assembly.
- Install the RH 2nd row headrest adjustment guide and guide lock. See:
- Adjustment Guide - Headrest - 2nd Row (Remove and Replace).Adjustment Guide - Headrest - 2ND Row (Remove And Replace)
- Guide Lock - Headrest - 2nd Row (Remove and Replace).Guide Lock - Headrest - 2ND Row (Remove And Replace)
- Install the RH 2nd row headrest. See Headrest - 2ND Row - Outer - LH (Remove And Replace) .
- Connect the 2nd row seat harness connector, and then secure the clips (x2) and elastic harness holder that attach the seat harness to the bottom side of the seat frame.
- Install the RH 2nd row seat toe kick cover. See Cover - Toe Kick - 2nd Row Seat - RH (7-Seat) - Remove And Replace .
- Install the RH 2nd row seat should switch. See Shoulder Switch - Seat Back - 2Nd Row - LH (Remove And Replace) .
- Install the RH 2nd row back panel. See Cover - Toe Kick - 2nd Row Seat - RH (7-Seat) - Remove And Replace .
- Move the RH 2nd row seat back to the vertical position.
- Move the front passenger seat to the original position.
- Raise the RH front and rear windows.
- Close the RH front and rear doors