Connector - General Information [Fremont/Berlin: 01/13/2021 - 01/06/2022 | Shanghai: 12/14/2020 - 11/15/2021]
How to use this document
This document is intended to assist in diagnosing electrical faults, and should be used in conjunction with the electrical circuit diagrams.
Connector Details
The color and gauge of the wires which populate each cavity are included in a table format. An example of this is given below.
| Cav | Col | Gauge |
|---|---|---|
| 1 | RD/TN | 0.50 |
| 2 | VT/WH | 0.50 |
| 3 | - | |
| 4 | PK/VT | 0.50 |
Wire colors
Wire colors are identified by a two letter code. When a wire has two codes separated by a '/', the first code represents the base color and the second code represents the stripe color. For example, "RD/WT" represents a red wire with a white stripe.
| Code | Color |
|---|---|
| BK | Black |
| BN | Brown |
| DB | Dark Blue |
| DG | Dark Green |
| GY | Gray |
| LB | Light Blue |
| LG | Light Green |
| OG | Orange |
| PK | Pink |
| VT | Violet (Purple) |
| RD | Red |
| TN | Tan |
| WT | White |
| YE | Yellow |
| NA | Coax-center |
| SH | Coax-shield |
| BU | Blue |
| GN | Green |
References
References to "LH" (left hand) or "RH" (right hand) are made when viewing the vehicle from the rear.