LEMON Manuals: Even more car manuals for everyone
Home >> Tesla >> 2021 >> Model Y Performance >> Repair and Diagnosis (Single Page) >> Body & Frame >> Door Locks >> Doors, Windows And Latches -- Model Y >> Latches Strikers And Pinch Sensors >> Striker - Liftgate - Remove And Replace >> Install

Striker - Liftgate - Remove And Replace: Install

  1. Align the trunk striker with the masking tape on the body, and then hand-tighten the bolts that attach the trunk striker to the body.
  2. Close the trunk and check gap/flush.
  3. Open the trunk and adjust the striker position as necessary.
  4. Repeat step  2 and step  3 until alignment is satisfactory.
  5. Fully tighten the bolts that attach the trunk striker to the vehicle.

    24 N.m 

    Tip: Use of the following tool(s) is recommended:

    • T45 socket
  6. Remove the masking tape and install the rear trunk sill trim. See Trim - Sill - Trunk (Remove and Replace) .
scientia non olet · About LEMON Manuals