Sensor - Parking Distance - Outer - Rear - Remove And Replace: Remove
- Remove the LH rear fender garnish. See GARNISH - FENDER - REAR - LH (REMOVE AND REPLACE) .
- Remove bolt that attaches the LH side of the rear fascia to the body.
4 N.m (2.9 ft-lbs)
Tip: Use of the following tool(s) is recommended:
- 8 mm hex
- 4 in extension
- Pull the rear fascia outward to allow clearance to the rear parking sensor.
- Disconnect the electrical harness from the rear parking distance sensor connector.NOTE: DO NOT push down on the red locking tab. Pull the tab away from the connector until the connector is unlocked, and then continue pulling to release the connector.
- Release the tabs that attach the rear parking distance sensor to the rear fascia, and then remove the sensor from the rear fascia.