Foam - Cushion - Front Passenger Seat - Remove and Replace: Install

Position the resistive occupancy sensor on top of the passenger seat cushion foam, and then route the sensor harness through the harness opening in the foam.
CAUTION: While installing the harness, take care not to damage the foam.

Figure 3. Resistive occupancy sensor positioned on top of the front seat cushion foam

Courtesy of TESLA, INC.

Figure 4. Resistive occupancy sensor harness routed through the bottom of the front seat

Courtesy of TESLA, INC.
Install the front passenger seat, seat cushion trim. See Trim - Cushion - Front Passenger Seat Remove and Replace .