Bracket - Rucket - LH - Remove and Replace: Install

Position the LH rucket bracket into the vehicle, and then install the clips (x2) that attach the bracket to the vehicle.
NOTE: Perform a push-pull-push test to verify the bracket is fully secure.

NOTE: The clip position should not be adjusted after bracket is removed or it will result in the bracket not seating properly. If the clip position is changed or the push-pull action shows the bracket is not secure, remove the clip from the tab, seat the clip into the doghouse on the bracket, and then reinstall.

Courtesy of TESLA, INC.

Courtesy of TESLA, INC.
Move the trunk tub liner into the original position, and then install the push clip that attaches the liner to the rucket bracket.

Courtesy of TESLA, INC.
Install the LH load floor bracket. See Bracket - Trunk Load Floor - LH - Remove And Replace .