Grille - Speaker - Instrument Panel - Remove And Replace: Install
- Replace any damaged clips on the instrument panel speaker grille.
- Position the instrument panel speaker grille into position on the instrument panel.
- Attach the clips that secure the instrument panel grille to the vehicle. Use a plastic pry stick to press the vertical clips forward to assist with inserting them into the IP carrier.
NOTE:
Make sure of the following:
- The instrument panel speaker grille forward hooks are fully engaged into the IP carrier.
- There is no gap at the bottom of the windshield.
Courtesy of TESLA, INC.
|
- Install the LH and RH upper A-Pillar trims. See Trim - A-Pillar - Upper - LH (Remove and Replace)
.
- Install the LH and RH middle A-pillar trims. See Trim - A-Pillar - Middle - LH (Remove and Replace)
.
- Install the LH and RH instrument panel end caps. See END CAP - INSTRUMENT PANEL - LH (REMOVE AND REPLACE) .