Bracket - Rear - Center - Remove And Replace: Install

Position the rear center bracket on the vehicle, and then install the tabs that attach each end of the rear center bracket to the body.
Tip: Assistance may be required to hold the bracket in place when performing this step.

Courtesy of TESLA, INC.
Install the bolts that attach the rear center bracket to the body.
4 N.m (2.9 ft-lbs)
NOTE:
Use of the following tool(s) is recommended:
- 10 mm socket
- 4 in extension
Courtesy of TESLA, INC.
Install the clips that attach the rear Bluetooth passive entry antenna electrical harness to the rear center bracket.

Courtesy of TESLA, INC.
Install the bolt that attaches the Bluetooth passive entry module to the body.
3.5 N.m (2.6 ft-lbs)
NOTE:
Use of the following tool(s) is recommended:
- 10 mm socket
- 4 in extension
Courtesy of TESLA, INC.
Connect the electrical wiring harness connector to the rear Bluetooth passive entry module.
CAUTION: Make sure the red locking tab is fully engaged.

Courtesy of TESLA, INC.
Install the rear fascia. See Fascia - Rear (Remove and Install) .