Light - Side Repeater - Front - LH - Remove And Replace: Remove
WARNING:
Whenever a camera has been moved out of its original position (for example, a camera or windshield replacement), camera calibration data must be cleared using the vehicle touchscreen: Controls
> Service
> Camera Calibration
> Clear Calibration
.
- Open the LH front door and lower the LH front window.
- Enable Service Mode by using the touchscreen. See SERVICE MODE .
- Apply protective tape to the LH front fender around the LH front side repeater light.
- Release the clips (x2) at the bottom of the LH front side repeater light attach the light to the LH front fender, and then separate the light from the fender.CAUTION: If reinstalling the same side repeater, take care not to damage the mounting tabs.NOTE: Carefully push the side repeater upwards and pry the bottom out to release it from fender. The number of clips may vary.
- Disconnect the electrical harness from the LH front side repeater light connectors (x2), and then remove the light from the vehicle.