LEMON Manuals: Even more car manuals for everyone
Home >> Tesla >> 2021 >> Model Y Performance >> Repair and Diagnosis (Single Page) >> Accessories & Equipment >> Headlights >> Electrical System -- Model Y (2 Of 2) >> Exterior Lights >> Light - Brake - Center High Mounted - Remove And Replace >> Remove

Light - Brake - Center High Mounted - Remove And Replace: Remove

  1. Remove the backlight glass. See GLASS - BACKLIGHT (REMOVE AND REPLACE) .
    CAUTION: When performing this procedure, make sure not to break the H-clips at the top of the backlight glass so that the new CHMSL can be installed onto the old backlight glass later.
  2. Press down the 2 clips on the CHMSL assembly to remove it from backlight glass.
    G00627570Courtesy of TESLA, INC.
  3. Remove remaining urethane from backlight assembly using a winged scrapper set.
    G00627571Courtesy of TESLA, INC.
  4. Remove the double sided tape residue on the locators (x2) area.

    Tip: Use of the following tool(s) is recommended:

    • Eraser Wheel
    • Battery Powered Drill - 1126456-00-A
    • Winged Scraper Set - 1080601-00-A
      G00627572Courtesy of TESLA, INC.
  5. Remove all spacer pads (x11).
    G00627573Courtesy of TESLA, INC.
  6. Remove remaining urethane from liftgate body using a winged scrapper set.
    NOTE: Make sure the residual urethane is 1 mm or less in thickness.
    G00627574Courtesy of TESLA, INC.
  7. Clean all mating surfaces with isopropyl alcohol (IPA) wipes.
    NOTE: Remove any finger prints or markings that will be visible under the CHMSL.
    G00627575Courtesy of TESLA, INC.
    G00627576Courtesy of TESLA, INC.
scientia non olet · About LEMON Manuals