LEMON Manuals: Even more car manuals for everyone
Home >> Tesla >> 2021 >> Model X Plaid >> Repair and Diagnosis (Single Page) >> Accessories & Equipment >> Seats >> Seats (2 Of 2) -- Model X >> 3rd Row Seat Covers Pads And Trims >> Substrate - Cushion - 3rd Row - Remove And Replace >> Install

Substrate - Cushion - 3rd Row - Remove And Replace: Install

  1. Install the new 3rd row cushion substrate on the cushion cover.
    G15405415Courtesy of TESLA, INC.
    G15405416Courtesy of TESLA, INC.
  2. Flip the 3rd row cushion assembly to access the bottom side.
    G15405417Courtesy of TESLA, INC.
  3. Install the J-hooks (x2) that attach the 3rd row cushion cover to the rear end of the cushion substrate.
    G15405418Courtesy of TESLA, INC.
  4. Install the J-hooks (x2) that attach the 3rd row cushion cover to both sides of the 3rd row cushion substrate.
    G15405419Courtesy of TESLA, INC.
  5. Install the J-hooks (x2) that attach the 3rd row cushion cover to the cup holder.
    G15405420Courtesy of TESLA, INC.
  6. Feed the 3rd row cushion connectors (x4) through the cushion cover.
    G15405421Courtesy of TESLA, INC.
  7. Install the J-hooks (x2) that attach the 3rd row cushion cover to the front end of the 3rd row cushion substrate.
    G15405422Courtesy of TESLA, INC.
  8. Install the tabs (x4) that attach the 3rd row cushion cover to the rear corners of cushion substrate.
    G15405423Courtesy of TESLA, INC.
    G15405424Courtesy of TESLA, INC.
    G15405425Courtesy of TESLA, INC.
  9. Flip the 3rd row cushion assembly to access the topside, and then inspect for any fitment issues.
    NOTE: If issues are present, correct the trim fitment, and then continue the procedure.
    G15405426Courtesy of TESLA, INC.
  10. Install the 3rd row seat cushion. See CUSHION - SEAT - 3RD ROW (REMOVE AND REPLACE) .
  11. Install the LH and RH 3rd row tray harnesses. See TRAY HARNESS - 3RD ROW - LH (REMOVE AND REPLACE) .
  12. Install the rear trunk carpet. See Carpet - Rear Trunk (7 Seat) (Remove and Replace) .
  13. Install the rear trunk floor NVH insulator. See NVH Insulator - Floor - Rear Trunk (Remove and Replace) .
  14. Install the rear trunk load floor. See Trunk Load Floor - Rear (Remove and Replace) .
  15. Connect LV power. See LV Power (Disconnect and Connect) .
  16. Install the rear underhood apron. See Underhood Apron - Rear (Remove and Replace) .
  17. Close the hood.
  18. Close the liftgate.
  19. Move the LH and RH monopost seats to original position.
  20. Move the LH and RH front seats to original position.
  21. Calibrate the rear doors.
    NOTE: If the "Calibration Needed" message appears on the vehicle touchscreen, touch and hold Calibrate  to calibrate the rear doors
  22. Raise the LH and RH front windows.
  23. Close the LH and RH front doors.
scientia non olet · About LEMON Manuals