Switch - Recliner - 3rd Row Seat - LH - Remove And Replace: Remove
- Open the LH and RH falcon wing doors.
- Open the liftgate.
- Fold the 2nd row 40 and 60 seats downward.
- Remove the rear trunk load floor. See Trunk Load Floor - Rear (Remove and Replace) .
- Remove the rear trunk floor NVH insulator. See NVH Insulator - Floor - Rear Trunk (Remove and Replace) .
- Remove the rear trunk carpet. See Carpet - Rear Trunk (5 Seat) (Remove and Replace) .
- Fold the LH and RH 3rd row seats downward.
- Remove the LH 3rd row seat back carpet. See SEAT BACK CARPET - 3RD ROW - LH (REMOVE AND REPLACE) .
- Release the tabs (x4), fir tree clips (x2), and J hook that attach the lower section of the LH 3rd row seat upholstery to the seat.NOTE: Pull the tabs inward, and then upwards to release.NOTE: Use of the following tool(s) is recommended:
- Clip pry tool
- Unfold the LH 3rd row seat to original position.NOTE: Leave the seat headrest in the folded position.
- Release the J-hook clip that attaches the upper half of the LH 3rd row seat upholstery to the seat.
- From the 3rd row, pull the top outer portion of the seat cover and foam outward to gain access to the LH 3rd row seat escutcheon.
- Carefully pull the LH 3rd row seat escutcheon forward to access the LH 3rd row seat recliner switch connector, and then disconnect the switch connector.
- Remove the screws (x2) that attach the LH 3rd row seat recliner switch to the seat, and then remove the switch from the seat.NOTE: Use of the following tool(s) is recommended:
- PH1 Phillips screwdriver