Bright Strip - Center Console - Rear - Remove And Replace: Install

Position the rear center console bright strip onto the center console, and then install the screws (x4) that attach the bright strip to the center console.
0.7 N.m (6 in-lbs)

NOTE: Rotate the bright work down into the center console, and then engage the datums.

Tip: Use of the following tool(s) is recommended:
- Torx T10 bit
Courtesy of TESLA, INC.

Courtesy of TESLA, INC.
Install the screws (x2) that attach the rear center console bright strip to the center console.
1 N.m (.7 ft-lbs)

Tip: Use of the following tool(s) is recommended:
- Torx T20 bit
Courtesy of TESLA, INC.

Courtesy of TESLA, INC.
Install the center console air wave assembly. See Air Wave Assembly - Center Console (Remove and Replace) .
NOTE: It is not necessary to run the Toolbox routine if the air wave assembly is not replaced.