Assembly - Trailer Hitch - Remove And Replace: Install

Position the trailer hitch assembly on the vehicle, and then install the nuts (x4) that attach the hitch assembly to the body studs.
60 N.m (44.2 ft-lbs)

NOTE: The new trailer hitch assembly comes equipped with an ECU and jumper harness.

Tip: Use of the following tool(s) is recommended:
- 15 mm deep socket
- Flex head ratchet/flex head torque wrench
- Ratchet/torque wrench
Courtesy of TESLA, INC.
Install the clip that attaches the LH body harness to the trailer hitch assembly.

Courtesy of TESLA, INC.
Connect the LH body harness connector to the trailer hitch assembly ECU.

Courtesy of TESLA, INC.
Connect the LH body harness connector to the trailer hitch assembly jumper harness.

Courtesy of TESLA, INC.
Install the rear fascia assembly. See Fascia Assembly - Rear (Remove and Install) .