LEMON Manuals: Even more car manuals for everyone
Home >> Tesla >> 2021 >> Model X Plaid >> Repair and Diagnosis (Single Page) >> Accessories & Equipment >> Gauges & Instrument Panels >> Infotainment System -- Model X >> Displays >> Touchscreen (HW3) - Remove And Replace >> Install

Touchscreen (HW3) - Remove And Replace: Install

  1. Tilt and lower the touchscreen display mechanism onto the display housing.
    NOTE: Make sure the plastic washers are present.
    G15408629Courtesy of TESLA, INC.
    G15408630Courtesy of TESLA, INC.
    G15408631Courtesy of TESLA, INC.
  2. Install new bolts (x2) that attach the touchscreen display mechanism to the display housing.

    10 N.m (7.4 ft-lbs) 

    Tip: Use of the following tool(s) is recommended:

    • 10 mm socket
    G15408632Courtesy of TESLA, INC.
  3. Install the bolt that attaches the touchscreen display housing ground strap to the display mechanism.

    4 N.m (2.9 ft-lbs) 

    NOTE: Inspect the bolt and replace if damaged.
    CAUTION: Failure to reconnect the ground strap will result in touchscreen functionality issues.

    Tip: Use of the following tool(s) is recommended:

    • Torx T20 socket
    G15408633Courtesy of TESLA, INC.
  4. Route the touchscreen harness behind the LH display bracket.
    G15408634Courtesy of TESLA, INC.
  5. Position the touchscreen assembly to the instrument panel, connect the touchscreen coax and power electrical connectors (x2), and then secure the clip that attaches the harness to the assembly.
    NOTE: Make sure the strain relief clip is secure to the linkage arm.
    NOTE: Replace the clip if damaged.
    G15408635Courtesy of TESLA, INC.
  6. Position the touchscreen shroud to the touchscreen assembly, and then secure the tabs (x3) that attach the shroud to the assembly.
    NOTE: Slide the touchscreen assembly downward until the shroud tabs fully engage.
    G15408636Courtesy of TESLA, INC.
    G15408637Courtesy of TESLA, INC.
  7. Install the touchscreen bracket bolts (x2).

    7 N.m (5.2 ft-lbs) 

    Tip: Use of the following tool(s) is recommended:

    • 10 mm socket
    G15408638Courtesy of TESLA, INC.
    G15408639Courtesy of TESLA, INC.
  8. Connect the electrical connectors (x2) for the touchscreen tilt motors, if equipped.
    G00662395
  9. Install the instrument panel service panel. See SERVICE PANEL - INSTRUMENT PANEL (REMOVE AND REPLACE) .
  10. Connect LV power. See LV Power (Disconnect and Connect) .
  11. Install the rear underhood apron. See Underhood Apron - Rear (Remove and Replace) .
  12. Move the front passenger seat to the original position.
  13. Calibrate the rear doors.
    NOTE: If the "Calibration Needed" message appears on the vehicle touchscreen, touch and hold Calibrate  to calibrate the rear doors
  14. Raise the front windows and close the RH front door.
scientia non olet · About LEMON Manuals