Closeout Panel - Door - Rear - LH - Remove And Replace: Remove
- Remove the LH rear door trim lower garnish. See Garnish - Lower - Door Trim - Rear - LH (Remove and Replace)
.
- Remove the LH rear door trim decor. See Decor - Trim - Rear Door - LH (Remove and Replace)
.
- Remove the LH rear door trim panel. See Panel - Door Trim - Rear - LH (Remove and Replace)
.
- Disconnect LV power. See LV Power (Disconnect and Connect)
.
- Release the orange locking tab, and then disconnect the LH falcon wing door air bag electrical connector.
Courtesy of TESLA, INC.
|
- Remove the screws (x10) that attach the LH rear door closeout panel to the LH rear door.
1.8 N.m (1.3 ft-lbs)
NOTE:
Use of the following tool(s) is recommended:
Courtesy of TESLA, INC.
|
- Remove the screws (x3) that attach the LH rear window motor to the LH rear door closeout panel.
1.8 N.m (1.3 ft-lbs)
NOTE:
Use of the following tool(s) is recommended:
Courtesy of TESLA, INC.
|
- Release the black locking tab, and then disconnect the LH falcon wing door protection ECU.
Courtesy of TESLA, INC.
|
- Disconnect the electrical connectors (x2) from the LH falcon wing door module.
Courtesy of TESLA, INC.
|
- Release the clips (x7) that attach the harnesses and connectors to the LH rear door closeout panel.
Courtesy of TESLA, INC.
|
- Release the clip, and then feed the door release cable through the LH rear door closeout panel.
Courtesy of TESLA, INC.
|
- Release the tabs (x2) that attach the LH rear door closeout panel to the LH rear door, pull the closeout panel away from door, and then lift the window motor upward to release it.
Courtesy of TESLA, INC.
|
Courtesy of TESLA, INC.
|
- Release the clip that attaches the LH rear window regulator to the LH rear door closeout panel.
Courtesy of TESLA, INC.
|
- Remove the screws (x3) that attach the LH rear door controller to the LH rear door closeout panel, and then remove the controller from the closeout panel.
NOTE:
Use of the following tool(s) is recommended:
Courtesy of TESLA, INC.
|
Courtesy of TESLA, INC.
|
- Remove the screws (x2) that attach the LH rear door ultrasonic ECU to the LH rear door closeout panel, and then remove the ECU from the closeout panel.
NOTE:
Use of the following tool(s) is recommended:
Courtesy of TESLA, INC.
|
Courtesy of TESLA, INC.
|
- Release the clip that attaches the dummy plug to the LH rear door closeout panel, and then remove the plug from the closeout panel.
Courtesy of TESLA, INC.
|
- Remove the clip in the LH rear door closeout panel.
Courtesy of TESLA, INC.
|