Fairing - Wheel - Front - LH - Remove And Replace: Remove

Open the LH front door and lower the LH front window.
Press the brake pedal to turn on drive rails.
On the center display, set the air suspension to "Jack Mode".
Release the clip and the tabs (x8) that attach the LH front wheel arch liner cover to the LH front wheel arch liner, and then remove the cover from the liner.

Courtesy of TESLA, INC.
Remove the clip that attaches the LH front wheel fairing to the LH front wheel arch liner.

Courtesy of TESLA, INC.
Remove the bolts (x2) and release the tab that attach the LH front wheel fairing to the valance, and then remove the fairing from the valance.
1.5 N.m (1.1 ft-lbs)

Tip: Use of the following tool(s) is recommended:
- 10 mm socket
Courtesy of TESLA, INC.
Starting from the rear, release the clips (x5) and tabs (x9) that attach the LH front fender garnish to the vehicle, disconnect the electrical connector, and then remove the garnish from the vehicle.
NOTE: Release the connector lock before disconnecting the electrical connector.

Courtesy of TESLA, INC.

Courtesy of TESLA, INC.
Remove the screw that attaches the LH front wheel fairing to the LH front fender garnish, and then remove the fairing from the garnish.
1.5 N.m (1.1 ft-lbs)

Tip: Use of the following tool(s) is recommended:
- T25 socket
Courtesy of TESLA, INC.

Courtesy of TESLA, INC.

Courtesy of TESLA, INC.