Seal - Lower NVH Extrusion - LH - Remove And Replace: Remove
- Measure the gap and flush of the LH falcon wing door according to specification.NOTE: Record the gap and flush data, and then use it as a base line when installing the door.
Tip: Use of the following tool(s) is recommended:
- Gap and flush tool
- Masking tape
- Pen
- Open the LH front door.
- Lower both of the LH side windows.
- Move the LH front seat forward.
- Open the LH falcon wing door.
- Remove the LH rear door trim lower garnish. See Garnish - Lower - Door Trim - Rear - LH (Remove and Replace) .
- Remove the LH rear door trim decor. See Decor - Trim - Rear Door - LH (Remove and Replace) .
- Remove the LH rear door trim panel. See Panel - Door Trim - Rear - LH (Remove and Replace) .
- With assistance, use an underhoist stand to support the LH falcon wing door.
Tip: Use of the following tool(s) is recommended:
- 3/4 Ton underhoist stand - 1081765-00-A
- Open the hood.
- Remove the rear underhood apron. See Underhood Apron - Rear (Remove and Replace) .
- On the touchscreen, touch Controls > Safety & Security > Power Off .
- Disconnect LV power. See LV Power (Disconnect and Connect) .
- Remove the LH lower rear door harness. See Harness - Rear Door - Lower - LH (Remove and Replace) .
- Mark the position of the LH rear lower door assembly to the LH rear upper door assembly.
Tip: Use of the following tool(s) is recommended:
- Marker
- Masking tape
- Remove the LH rear lower door assembly. See Door Assembly - Rear Lower - LH (Remove and Replace) .
- Remove the LH lower NVH extrusion seal from the LH rear lower door assembly.