Actuator - Headrest - 3rd Row - LH - Remove And Replace: Install
- Position the LH 3rd row headrest actuator on the vehicle, install the headrest release cable at the base of the actuator, and then slide the cable to the end of the actuator to lock the cable on the actuator.
- Install the screws (x2) that attach the LH 3rd row headrest actuator to the seat frame.
2 N.m (1.5 ft-lbs)
NOTE: Use of the following tool(s) is recommended:- Ratchet/torque wrench
- Torx T25 socket
- Connect the LH 3rd row headrest actuator connector.
- Fold the seat upholstery and cushion assembly over the seat frame.NOTE: Use the folding function to assist with tucking the upholstery.
- Engage the J hook clip that attaches the upper half of LH 3rd row seat upholstery to the seat.NOTE: Fold the seat to a workable position, start at one end of the J hook clip, and then fold the clip inwards until the other end of the upholstery is fully tucked.
- Disconnect the LH 3rd row seat connectors (x2), and then route the connectors through the seat upholstery.
- Connect the LH 3rd row seat connectors (x2).
- Engage the tabs (x4), fir tree clips (x2), and J hook that attach the lower section of the LH 3rd row seat upholstery to the seat.
- Install the LH 3rd row seat back carpet. See SEAT BACK CARPET - 3RD ROW - LH (REMOVE AND REPLACE) .
- Install the rear trunk carpet. See Carpet - Rear Trunk (5 Seat) (Remove and Replace) .
- Install the rear trunk floor NVH insulator. See NVH Insulator - Floor - Rear Trunk (Remove and Replace) .
- Install the rear trunk load floor. See Trunk Load Floor - Rear (Remove and Replace) .
- Unfold the LH and RH 3rd row seats into original position.
- Close the liftgate.
- Unfold the 2nd row 40 and 60 seats into original position.
- Close the LH and RH falcon wing doors.