Cover - Shock Tower - LH - Remove And Replace: Install
- Lift the LH side of the cowl screen, and the fold the shock tower cover around the cowl screen to position it into the vehicle.
 Courtesy of TESLA, INC.
|
- Install the clips (x3) that attach the LH shock tower cover to the vehicle.
 Courtesy of TESLA, INC.
|
- Install the clip that attaches the LH speed sensor harness to the vehicle.
 Courtesy of TESLA, INC.
|
- Position the LH outer hood hinge cover into the vehicle, and then install the clip that attaches the cover to the vehicle. Repeat this step for the RH outer hood hinge cover.
 Courtesy of TESLA, INC.
|
 Courtesy of TESLA, INC.
|
- Install the underhood storage unit. See Underhood Storage Unit (Remove and Install)
.
- Install the front underhood apron. See UNDERHOOD APRON - FRONT (REMOVE AND REPLACE) .
- Install the LH and RH underhood aprons. See UNDERHOOD APRON - LH (REMOVE AND REPLACE) .
- Install the rear underhood apron. See UNDERHOOD APRON - REAR (REMOVE AND REPLACE) .
- Raise the LH front window and close the LH front door.