Carrier - Stanchion - Passive Spoiler - LH - Remove And Replace: Remove

Open the LH front door.
Lower the LH front window.
Open the liftgate.
Remove the backlight glass. See Backlight Glass (Remove And Install) .
Use a marker or masking tape to mark the original location of the LH passive spoiler stanchion carrier on the backlight glass.
Tip: Use of the following tool(s) is recommended:
- Marker
- Masking tape
Courtesy of TESLA, INC.
Carefully remove the LH passive spoiler stanchion carrier from the backlight glass.
Tip: Use of the following tool(s) is recommended:
- Plastic trim tool
Courtesy of TESLA, INC.

Courtesy of TESLA, INC.
Use IPA wipes to clean the surface area in preparation for the LH passive spoiler glass stanchion carrier installation.
NOTE: Allow 1 minute dry time.

Tip: Use of the following tool(s) is recommended:
- Battery powered drill - 1126456-00-A
- Eraser wheel
- Winged scraper set - 1080601-00-A
Courtesy of TESLA, INC.