LEMON Manuals: Even more car manuals for everyone
Home >> Tesla >> 2021 >> Model X Performance >> Repair and Diagnosis (Single Page) >> Accessories & Equipment >> Interior/Exterior Trim >> Body -- Model X >> Bumper/Fascia >> V Bar - Fascia - Front - Remove And Replace >> Remove

V Bar - Fascia - Front - Remove And Replace: Remove

  1. Press the brake pedal to turn on drive rails.
  2. Use the touchscreen to set the air suspension ride height to "Very High."
  3. Use the touchscreen to set the air suspension into "Jack Mode."
  4. Turn the steering wheel fully to the right.
  5. Remove the rear underhood apron. See Underhood Apron - Rear (Remove and Replace) .
  6. Remove the LH and RH underhood aprons. See Underhood Apron - LH (Remove and Replace) .
  7. Remove the front underhood apron. See Underhood Apron - Front (Remove and Replace) .
  8. Remove the underhood storage unit. See Underhood Storage Unit (Remove and Install) .
  9. Remove the front fascia assembly. See FASCIA ASSEMBLY - FRONT (REMOVE AND INSTALL) .
  10. Remove the front fascia T badge support. See T BADGE SUPPORT - FASCIA - FRONT (REMOVE AND REPLACE) .
  11. Release the clips (x4) that attach the front fascia V bar from to the T badge support.
    G15389307Courtesy of TESLA, INC.
    G15389308Courtesy of TESLA, INC.
scientia non olet · About LEMON Manuals