Speaker - Dash - LH - Remove And Replace: Install

Connect the electrical connector and install the screws (x3) that attach LH dash speaker to the IP sub-assembly.
3 Nm (2.2 lbs-ft)
- Torx T20 socket
- Flex head ratchet/flex head torque wrench
- Wurth in hexagon 1 Nm - 5 Nm torque wrench (installation only)
Courtesy of TESLA, INC.

Courtesy of TESLA, INC.
Install the screws (x9) that attach the dash speaker mesh to the IP sub-assembly.
3 Nm (2.2 lbs-ft)
- Torx T20 socket
- Wurth in hexagon 1 Nm - 5 Nm torque wrench (installation only)
- 2 in extension
Courtesy of TESLA, INC.

Courtesy of TESLA, INC.

Courtesy of TESLA, INC.
Use IPA wipes to clean around the seal and install IP sub-assembly seal.
Install the IP sub-assembly. See Sub Assembly - Instrument Panel (Remove and Replace)