Antenna - GPS - Remove And Replace: Install
- Position the GPS antenna into the vehicle, and then install the bolt and secure the tabs (x2) that attach the antenna to the vehicle.
1 N.m (.7 ft-lbs)
Tip: Use of the following tool(s) is recommended:
- Torx T10 bit
- Connect the GPS antenna electrical connector.
- Secure the clips (x4) that attach the upper portion of the rear view mirror cover to the vehicle.NOTE: Make sure the rear view mirror harness is routed so that it hangs freely on the outside and is not pinched between the cover and glare shield assembly.
- Install the rear view mirror. See Mirror - Rear View (Remove and Replace) .
- Install the lower camera cover. See Camera Cover - Lower (Remove And Replace)
- Raise the LH front window and close the LH front door.