Bracket - Zone - C-Pillar - Mid - LH (6/7 Seat) - Remove And Replace: Install
- Position the LH mid C-pillar zone bracket into the vehicle, and then install the screws (x2) and push clips (x4) that attach the bracket to the vehicle.
2.5 N.m (1.8 ft-lbs)
Tip: Use of the following tool(s) is recommended:
- T20 socket
- Install the clip that attaches the charge port manual cable release to the LH mid C-pillar zone bracket.
- Install the LH upper C-pillar trim. See TRIM - C-PILLAR - UPPER - LH (REMOVE AND REPLACE) .
- Fold the LH 3rd row seat back into the upright position.
- Install the LH lower C-pillar trim. See TRIM - C-PILLAR - LOWER - LH (REMOVE AND REPLACE) .
- Install the LH mid C-pillar trim. See TRIM - C-PILLAR - MID - LH (REMOVE AND REPLACE) .
- Position the LH soft trim pocket bracket into the vehicle, and then install the push clip that attaches the bracket to the vehicle.
- Install the clips (x3) that attach the LH crush can bracket to the vehicle.
- Install the clips (x6) that attach the rear wall load floor support to the vehicle.
- Install the trunk sill trim. See TRIM - SILL - TRUNK (REMOVE AND REPLACE) .
- Install the LH and RH side rear trunk garnishes. See GARNISH - REAR TRUNK - SIDE - LH (REMOVE AND REPLACE) .
- Install the trunk carpet.
- Install the trunk tub floor insulator.
- Install the side trunk load floor. See TRUNK LOAD FLOOR - SIDE (REMOVE AND REPLACE) .
- Install the rear trunk load floor. See TRUNK LOAD FLOOR - REAR (REMOVE AND REPLACE) .
- Install the LH rear sill panel trim. See TRIM - SILL PANEL - REAR - LH (REMOVE AND REPLACE) .
- Close the LH rear door.