LEMON Manuals: Even more car manuals for everyone
Home >> Tesla >> 2021 >> Model X Long Range Plus >> Repair and Diagnosis (Single Page) >> Accessories & Equipment >> Interior/Exterior Trim >> Body -- Model X >> Bumper/Fascia >> Air Extractor - Rear - Outer - LH - Remove And Replace >> Remove

Air Extractor - Rear - Outer - LH - Remove And Replace: Remove

  1. Remove the LH trunk trim bracket. See Bracket - Trim - Trunk - LH (Remove and Replace) .
  2. Release the clips (x2) that attach the LH rear wheel house absorber to the body, and then move the absorber to gain access.
    NOTE: Move towards the front of the vehicle to gain access.
    G15389007Courtesy of TESLA, INC.
    G15389008Courtesy of TESLA, INC.
    G15389009Courtesy of TESLA, INC.
  3. Remove the LH rear fender garnish. See Garnish - Fender - Rear - LH (Remove and Replace) .
  4. Remove the screw that attaches the LH rear fascia to the rear quarter panel.

    1.5 N.m (1.1 ft-lbs) 

    Tip: Use of the following tool(s) is recommended:

    • Torx T25 bit
    G15389010Courtesy of TESLA, INC.
  5. Release the tabs (x12) to partly detach the LH rear fascia from the rear quarter panel.
    G15389011Courtesy of TESLA, INC.
  6. Release the clips (x4) that attach the LH outer rear air extractor to the body.
    G15389012Courtesy of TESLA, INC.
  7. Pull back the LH rear fascia to gain access.
    NOTE: Carefully pull back LH rear fascia trim quarter to gain access to the LH outer rear air extractor.
    G15389013Courtesy of TESLA, INC.
  8. Remove the LH outer rear air extractor from the vehicle.
    G15389014Courtesy of TESLA, INC.
    G15389015Courtesy of TESLA, INC.
scientia non olet · About LEMON Manuals