LEMON Manuals: Even more car manuals for everyone
Home >> Tesla >> 2021 >> Model X Long Range Plus >> Repair and Diagnosis (Single Page) >> Accessories & Equipment >> Accessories Control Systems >> Doors, Windows And Latches -- Model X >> Latches, Strikers, And Pinch Sensors >> Striker - Liftgate - Remove And Replace >> Remove

Striker - Liftgate - Remove And Replace: Remove

  1. Open the LH front door and lower the LH front window.
  2. Remove the trunk load floor. See Trunk Load Floor - Rear (Remove and Replace) .
  3. Remove the LH and RH side rear trunk garnish. See Garnish - Rear Trunk - Side - LH (Remove and Replace) .
  4. Remove the trunk sill trim. See Trim - Sill - Trunk (Remove and Replace) .
  5. Apply masking tape around the liftgate striker to mark the position.
    G15391892Courtesy of TESLA, INC.
  6. Remove the bolts (x2) that attach the liftgate striker to the body, and then remove the striker from the vehicle.

    22 N.m (16.2 ft-lbs) 

    Tip: Use of the following tool(s) is recommended:

    • T30 socket
    G15391893Courtesy of TESLA, INC.
    G15391894Courtesy of TESLA, INC.
scientia non olet · About LEMON Manuals