Scuff Plate - Rocker Panel - LH - Remove And Replace: Install
- Remove the adhesive strip from the LH body side secondary seal, and then clean the seal with an Isopropyl Alcohol (IPA) wipe. Allow 1 minute to dry.
 Courtesy of TESLA, INC.
|
- Position the front end of the LH rocker panel scuff plate between the LH rear door and body, and then slide the scuff plate forward.
 Courtesy of TESLA, INC.
|
- Fasten the bottom clips (x7), and then the upper tabs (x7) that attach the LH rocker panel scuff plate to the LH rocker panel.
 Courtesy of TESLA, INC.
|
- Apply a new adhesive strip to the LH body side secondary seal where the previous strip was removed.
 Courtesy of TESLA, INC.
|
- Fasten the clip that attaches the LH body side secondary seal to the rear of the LH rocker panel scuff plate.
 Courtesy of TESLA, INC.
|
- Press the body side secondary seal down onto the rear of the LH rocker panel scuff plate to attach the adhesive strip, and then press the length of the seal onto the scuff plate in a forward motion.
 Courtesy of TESLA, INC.
|