LEMON Manuals: Even more car manuals for everyone
Home >> Tesla >> 2021 >> Model S Plaid >> Repair and Diagnosis (Single Page) >> Body & Frame >> Exterior Body Panels >> Body -- Model S >> Bumper/Fascia >> Bracket - Rear Wing - LH - Remove And Replace >> Remove

Bracket - Rear Wing - LH - Remove And Replace: Remove

  1. Remove the rear fascia assembly. See Fascia Assembly - Rear (Remove And Install) .
  2. Remove the clips that attach the LH rear wing bracket to the vehicle.
    NOTE: Rotate clips counterclockwise, and then pull gently to release. The clips must be fully released to remove the bracket.

    Tip: Use of the following tool(s) is recommended:

    • PH2 Phillips screwdriver
    • 6 in 90 degree pick
    • Plastic trim tool
    G15077147Courtesy of TESLA, INC.
    G15077148Courtesy of TESLA, INC.
    G15077149Courtesy of TESLA, INC.
    G15077150Courtesy of TESLA, INC.
scientia non olet · About LEMON Manuals