Switch - Seat Fold - 2nd Row - RH - Remove And Replace: Install

Position the RH 2nd row seat fold switch onto the shoulder plastic trim, and then secure the tabs (x2) that attach the switch to the trim.

Courtesy of TESLA, INC.
Position the RH 2nd row shoulder plastic trim onto the seat frame assembly, connect the RH 2nd row seat fold switch electrical connector, and then secure the clips (x6).
NOTE: Align the fold switch with the frame gap to avoid damage.

Courtesy of TESLA, INC.

Courtesy of TESLA, INC.

Courtesy of TESLA, INC.
Install the clips (x3) that attach the RH 2nd row shoulder plastic trim to the frame assembly.

Courtesy of TESLA, INC.
Position the RH 2nd row backrest cushion to the backrest frame, connect the electrical connector, and then fasten the clips (x8).
NOTE: Secure the lower clips then the connect backrest harness. Make sure all the clips are seated.

Courtesy of TESLA, INC.

Courtesy of TESLA, INC.

Courtesy of TESLA, INC.
Fold the RH 2nd row seat to the down position.
Install the bolts (x2) that attach the RH 2nd row backrest cushion to the frame assembly.
8 N.m (5.9 ft-lbs)

Tip: Use of the following tool(s) is recommended:
- 10 mm socket
Courtesy of TESLA, INC.
Install the RH 2nd row headrest guide locks. See Guide Lock - Headrest - 2nd Row (Remove And Replace) .
Remove the RH 2nd row headrest. See Headrest - 2nd Row - LH (Remove And Replace)
Install the clip that attaches the RH 2nd row shoulder plastic trim to the latch assembly.

Courtesy of TESLA, INC.
Position the RH 2nd row back side cover to the seat assembly, and then install the clips (x2) that attach the cover to the seat assembly.

Courtesy of TESLA, INC.

Courtesy of TESLA, INC.
Install the RH 2nd row seat back panel. See Back Panel - 2nd Row Seat - RH (Remove And Replace) .
Fold the RH 2nd row seat to the up position, and remove the seat protection if present.
Move front passenger seat to the original position.
Raise the RH windows and close the RH doors.