LEMON Manuals: Even more car manuals for everyone
Home >> Tesla >> 2021 >> Model S Plaid >> Repair and Diagnosis (Single Page) >> Accessories & Equipment >> Interior/Exterior Trim >> Body -- Model S >> Windshield, Liftgate Glass, and Body Glass >> Glass - Rear Quarter - LH - Remove And Replace >> Install

Glass - Rear Quarter - LH - Remove And Replace: Install

  1. Use an IPA wipe to clean the quarter panel surface area.
    NOTE: Allow 1 minute dry time.
    G15078591Courtesy of TESLA, INC.
  2. Apply primer to the urethane path and any areas where the paint was damaged during the removal of the LH rear quarter glass. Allow the primer to dry for at least 2 minute.
    G15078592Courtesy of TESLA, INC.
  3. Install the body patches (x2) from the quarter panel.
    G15078593Courtesy of TESLA, INC.
  4. Prepare the caulking gun and urethane.
    NOTE: The urethane opening must be 7 mm wide and 12 mm tall.
  5. Apply urethane to the LH rear quarter glass, following the original path.
    NOTE: If quarter glass is being reused, apply urethane surrounding the datum location. This will eliminate potential wind noise.
  6. Position the LH rear quarter glass onto the vehicle.
    NOTE: Start by positioning the datum into place. Verify the threads for bolt installation are aligned with the body. Apply pressure to the surrounding areas. Use tape to hold glass in place. Reference urethane being applied to confirm dry time.
    G15078594Courtesy of TESLA, INC.
  7. Install the bolts (x2) that attach the LH rear quarter glass to the body.

    Torque 10 N.m 

    Tip: Use of the following tool(s) is recommended:

    • 10 mm socket
    G15078595Courtesy of TESLA, INC.
    G15078596Courtesy of TESLA, INC.
  8. Remove the masking tape from the LH rear quarter glass.
  9. Use an IPA wipe to clean the LH rear quarter glass and surrounding area of any residual debris.
    NOTE: Allow 1 minute dry time.
  10. Install the LH rocker panel seal to the quarter panel area.
    NOTE: Apply promoter to the double sided tape. If damage is present on double sided tape, replace with a new piece.
    G15078597Courtesy of TESLA, INC.
  11. Install the LH body side brightwork. See Brightwork - Body Side - LH (Remove and Replace) .
  12. Move the LH upper C-pillar trim into position, and then fasten the clips (x7) that attach the trim to the vehicle.
    G15078598Courtesy of TESLA, INC.
    G15078599Courtesy of TESLA, INC.
    G15078600Courtesy of TESLA, INC.
  13. Install the LH mid C-pillar trim, See Trim - C-Pillar - Mid - LH (Remove and Replace) .
  14. Install the LH lower C-pillar trim. See Trim - C-Pillar - Lower - LH (Remove and Replace) .
  15. Install the 2nd row lower seat cushion. See Seat Cushion - Lower - 2nd Row (Remove and Replace) .
  16. Install the LH 2nd row seat outer side bolster. See Bolster - Outer - Seat - 2nd Row - LH (Remove and Replace) .
  17. Install the rear trunk parcel shelf. See Parcel Shelf - Rear Trunk (Remove and Replace) .
scientia non olet · About LEMON Manuals