Trim - Bolster - Inner - Seat - 2nd Row - LH - Remove and Replace: Remove
- Open the RH front door and lower the RH front window.
- Open the RH rear door.
- Move the front passenger seat fully forward.
- Remove the RH 2nd row seat back panel. See Back Panel - 2nd Row Seat - RH (Remove And Replace) .
- Remove the bolt that attaches the bolster assembly to the seat back frame.
8 N.m (5.9 ft-lbs)
Tip: Use of the following tool(s) is recommended:
- 10 mm deep socket
- Release the clips (x2) that attach the RH 2nd row bolster assembly to the seat back, and then remove the bolster assembly from the seat back.
- Release the hooks (x2) that attach the bottom portion of the RH 2nd row seat inner bolster trim to the bolster substrate.
- Release the clip that attaches the RH 2nd row seat inner bolster trim to the bolster substrate.
- Release the clips (4x) that attach the edge of the RH 2nd row seat inner bolster trim to the bolster substrate.
- Pull the RH 2nd row seat inner bolster trim and away from the edge of the bolster substrate.NOTE: Press the substrate down to give the trim more clearance and reduce strain on the stitching.
- Remove the RH 2nd row bolster substrate.
2 - Remove the RH 2nd row bolster foam from the RH 2nd row seat inner bolster trim.